This is a two-piece containment box known as a Clamp designed to go over Valves, Flanges, etc. that are leaking on a system that cannot be shut down. The Machinist will bolt the clamp in place (over the leaking item) then start pumping in a high temp compound encapsulating the leak so they can run until the next shut down. Refineries mainly use these. I was called to weld the sealing rings that surround the pipe itself and the Box Seal at the separation point.
EXPERTISE:
- Commercial Work, Classic restorations, Custom Exhaust, Frames, Structural welding
- Small to large scale piping jobs that operate under high pressure and temperature service, sanitary welding
- Platform construction and repairs including redesigning and or replacement
- Custom fabrication of guards, handrails, safety covers, and shields to comply with OSHA and Cal OSHA regulations.
- Overlay and weld build-up using Stellite and other hard-facing Alloys.
DON CROSSLEY
Phone: (707) 580-4727
Fax: (707) 435-WELD (9353)
ON-SITE MOBILE
Fairfield, CA 94533
Email: the_croz@hotmail.com
Lic# 991945 TIN: 46 4815004
C13, C23, C51, C60 – Welding Contractor
Contractors State License Board
Contractor’s Bond #04-WB045676
No comments:
Post a Comment